Name: Last Stop Diesel
Address: 4C Danville Rd, Plaistow, NH, 03865
Telephone: (978) 891-3254

2004 Ford F550 Super Duty
Mileage
112,250
Service Date
7/24/2026
Services Performed
verified concern. found truck to have cylinder 4 contribution code. monitored injector flow with scan tool. found cylinder 4 injector to be out of spec. recommend cylinder 4 injector
removed coolant bottle, FCIM and valve cover in order to access fuel injector. found one of the stand pipe o rings to be ripped. R&R stand pipes and dummy plugs on the drivers side. R&R cylinder 4 injector and re installed FCIM can coolant bottle. bled cooling system.
R&R water filter separator assembly
Dennis V. gave our service a 5 star review on 7/25/2026
2016 Ford F-350 Super Duty
Mileage
123,707
Service Date
7/20/2026
Services Performed
verified concern. scanned for codes and found a cylinder 8 contribution code. when started up, noticed knock on the opposing cylinder as well. performed relative compression test. and found cylinder 8 to be lower than spec. recommend removal of both valve covers to inspect valvetrain.
removed upper and lower intakes, boost tubes, all injectors, CCV filter and EGR cooler to access valve covers. removed valve covers and found no valvetrain issues. suspect lower end engine damage.
evacuated A/C and drained both cooling systems. removed cab mounts in order to raise cab. removed turbo in order to install engine lift plate. removed engine and begun swapping over components. swapped over valve covers, engine harness, both alternators, secondary water pump, all pulleys. installed new fuel injectors and fuel rails. installed DCR pump. installed engine and re installed turbo. cleaned and installed upper and lower intakes. lowered cab and installed S&B cab mounts. installed CAT oil filter and adapter. programmed all 8 new injectors and cleared adaptive tables. re charged A/C and bled cooling systems. took vehicle for multiple extended road test. no issues present at this time
3 of the 8 cage nuts for the cab mounts froze requiring extraction. extracted cab mount bolts.
removed running boards in order to lift the cab
removed lots of after market wiring in order to lift the cab. re wired accessories when cab was lowered back down
R&R CCV filter
Daniel P. gave our service a 5 star review on 7/22/2026
2006 Ford Pickup
Mileage
173,094
Service Date
6/5/2026
Services Performed
Performed LOF, greased front end and topped off vital fluids to vehicle. No further action needed at this time.
ENGINE COMPRESSION – Testing – F250 Super Duty, F350 Super Duty, V8, 6.0L Eng, Diesel – [NOTE: Add 0.2 for wet compression retest.]
Perfomed MPI, thoroughly looked over vehicle and provided customer with any recommendations.
Install Customer Supplied Regulated Fuel Return System
TURBOCHARGER – Remove & Replace – F250 Super Duty, F350 Super Duty
COOLANT RECOVERY TANK – Remove & Replace – F250 Super Duty, F350 Super Duty, Diesel
SHOCK &/OR STRUT ASSEMBLY – Remove & Install or Remove & Replace – F250 Super Duty, F350 Super Duty Both – [DOES NOT include disassemble or alignment.]
SHOCK &/OR STRUT ASSEMBLY – Remove & Install or Remove & Replace – F250 Super Duty, F350 Super Duty Both – [DOES NOT include disassemble or alignment.]
Replace front & rear brake pads & rotors, clean & lube all contacts. Clean, lube & adjust e-brake. Top off diff fluid if required. Road test vehicle.
PARKING BRAKE SHOE & LINING – Remove & Replace – F250 Super Duty, F350 Super Duty Rear, Both Sides, Full Floating Axle, Inboard Mounted Rotor, w/Dual Rear Wheels – [Includes: Repack Wheel Bearings.] – [Includes: Replace Rear Disc Brake Pads (if necessary)
TRANSMISSION OIL FILTER – Remove & Replace – F250 Super Duty, F350 Super Duty Pan,Filter
TRANSMISSION OIL FILTER – Remove & Replace – F250 Super Duty, F350 Super Duty Line,Filter
Remove original bed from vehicle with fork lift, lower flat / utility bed onto frame with fork lift for mock up. Fabricate 1 inch square tube spacers for front sections of cross member supports & align for proper cab clearance, wheel well spacing, and center. Spacers leveled bed true verified with bubble level. Customer mentioned welding on a trailer receiver to new bed, bed rails do not exactly match frame and spacers / hold down bolts deemed a liability for towing purposes. Recommend custom flat / utility bed shop.
FUEL TANK – Remove & Replace – F250 Super Duty, F350 Super Duty – [Includes: Drain and fill.] Install Customer Supplied S&B 60 Gallon Tank
Diagnose & Advise Pillar Gauges Inop
FUEL INJECTION POWER MODULE – Remove & Replace – F250 Super Duty, F350 Super Duty, 6.0L Eng FICM – [Includes: Programming.]
WATER PUMP – Remove & Replace – F250 Super Duty, F350 Super Duty, Automatic Trans, Diesel w/o Dual Alternators
FRONT BUMPER – Remove
Dennis V. gave our service a 5 star review on 6/5/2026
2021 Ford F-550 Super Duty
Mileage
74,681
Service Date
4/6/2026
Services Performed
Self test codes: P008A (low pressure fuel system pressure – too low)PCM , B10F3 (left front position light)BCM, B10F4 (right front position light)BCM, B1380 (steering wheel right switch pack)SCCM, U2101 (control module configuration incompatible)SCCM. PID monitor low side fuel system pressure, 76psi. Recent Ford OE fuel filters replaced, check for leaks none. Check lower filter hosing, found 2 hold down bolts not fully seated. Bolts binding up during tightening attempt. R&R lower fuel filter & inspect, filter ok. Chase & clean threads, tighten to spec.
FUEL FILTER – Remove & Replace – Diesel On Tank, Assembly, w/o Fuel Tank Removal
Check for modules requiring later calibration files via OE server, update / reprogram all modules available. Clear codes & retest / let run & road test, allok.
Joe C. gave our service a 5 star review on 4/16/2026
2004 Ford Cab & Chassis
Mileage
148,466
Service Date
1/23/2026
Services Performed
REPLACE BROKEN CLAMP AND REALIGN PIPE TO TURBO
REPLACE COOLANT BOTTLE DUE TO IT LEAKING FROM BEING MELTED
Shane S. gave our service a 5 star review on 1/23/2026
2019 Ford F-350 Super Duty
Mileage
141,603
Service Date
11/21/2025
Services Performed
VIBRSTION COM ING FROM FRONT HUBD BEING LOCKED HORN WORKS WITH NO ISSUES
UNBOLTED OLD TIE ROD AND COUNTED THREADS AND REPLACED WITH NEW TIE ROD AND AND RETIGHTEND EVERYTHING TO SPEC
REMOVED HUB AND KNUCKLE AND AXLE SHAFT PRESSED OUT OLD BLOWN OUT BALL JOINTS AND REPLACED WITH NEW BALL JOINTS AND REGRESSED AND RE INSTALLED KNUCKLE AND HUB ASSEMBLY
Replace front brake pads and rotors. Clean and lubricate brake calipers and slide mechanisms. Check and fill brake fluid. Bleed air from system. Road test vehicle.
Replace rear brake linings. Inspect condition and thickness of rear brake disc rotors. Retract rear brake caliper actuators. Clean and lubricate rear brake caliper slide mechanism. Adjust parking brake. Road test vehicle.
REMOVED 4 BOLTS AND TUBE FROM THE BREATHER AND REMOVED AND REPLACED WITH NEW CCV AND RETIGHTEND TO SPEC
Perform LOF With BG Diesel Oil Conditioner, Replace Fuel Filters & Install BG Diesel Fuel System Cleaner, Replace Air filter, Top Off Fluids, Rotate Tires & Set Pressures, Inspect Front & Rear Brakes, Steering & Suspension, Grease All Zerk Fittings, Perform Multi-Point Inspection.
Ricardo F. gave our service a 5 star review on 11/21/2025
2017 Ford F-350 Super Duty
Mileage
207,337
Service Date
11/8/2025
Services Performed
removed transmission to access upper oil pan. during removal of transfer case skid plate all 4 bolts spun inside the frame. extraction is required. removed upper oil pan and cleaned off engine block. installed older gasket style upper oil pan and new lower oil pan. let sealant cure over night before oil was put into truck. re installed transmission. added engine oil and took vehicle for multiple road test. no leaks from oil pans at this time.
R&R CCV filter
Cut all seized bolts & remove threaded clip retainers. Grind areas / holes on frame which bolts are fastened to, weld in flange nuts. Install new flange bolts with antiseize to prevent future concerns.
Jay W. gave our service a 5 star review on 11/10/2025
2011 Ford Cab & Chassis
Mileage
113,659
Service Date
10/9/2025
Services Performed
R&R both exhaust manifolds
found 2 bolts to be broken on the drives side. extracted both bolts and replaced all hardware
verified concern. found back up alarm to be wired improperly. cut one wire to the back up alarm. found 2 cab lights to be out.
Perfomed MPI, thoroughly looked over vehicle and provided customer with any recommendations.
Replace drivers outer tie rod end.
Road test vehicle. Check all suspension and steering parts for wear. Check tire pressure and condition. Check riding height. Check alignment of all four wheels. Adjust caster, camber, toe-in, and thrust angle as needed on all four wheels. Center ste
R&R customer supplied washer fluid pump
R&R 2 cab light bulbs
R&R rotted power steering line
Andrew R. gave our service a 5 star review on 10/9/2025
2012 Ford Pickup
Mileage
500,913
Service Date
8/15/2025
Services Performed
Performed LOF, greased front end and topped off vital fluids to vehicle. No further action needed at this time.
Jaime M. gave our service a 5 star review on 8/16/2025
2006 Ford Pickup
Mileage
134,214
Service Date
7/30/2025
Services Performed
Self test codes: pass. Oil level & condition ok (slightly low). Low side oil pressure slow to build, PID monitor ICP / IPR / FICM. ICP slow to build & IPR 85%. Leak present. Air test h.pres system, pass. Recent stand pipes, dummy plugs & IPR. Suspect h.pres pump. Able to start with silicone spray, would remain running until oil temp rose above 140 degrees and IPR increased. Recommend replacement of h.pres pump & retest.
R&R engine oil filter
removed intake and turbo to access high pressure oil pump. turbo had no endplay. during removal of the intake, notices both belts to be cracked. replaced both belts with heavy duty ones. R&R high pressure oil pump and primed system. re installed turbo and intake.
removed intake to access oil cooler. R&R oil cooler and replaced all seals. re installed intake
installed coolant filter kit
Scott R. gave our service a 5 star review on 7/30/2025

Ford